Step 1
Loosen the nut on the exterior of your chosen mounting hub location until there are only a few visible bolt threads between the nut and the smooth part of the eyebolt.
Step 2
Tighten the eyebolt on the hub exterior by turning it clockwise until the nut rests against the washer.
Step 3
Re-tighten the exterior nut to secure this new eyebolt depth.
Step 4
Remove the nut on the interior of your chosen mounting hub location.
Step 5
Place the JiffyLink™ Mount over the exposed eyebolt and onto the hub.
Step 6
Restore the interior nut over the Mount and fasten it securely.
Step 7
Confirm that the nylon on the interior locking nut is fully engaged with the eyebolt threads. If not, return to Step 1 and loosen the exterior nut further.
Usage
With the Mount now successfully attached, simply slide the mounting plate of any JiffyLink™ accessory onto the Mount until it clicks into place for use.
Adapters
Note that some JiffyLink™ accessories (Cup Holder and Tray) come with Angled and Perpendicular adapters. These are intended to either compensate for the flare of the shelter, or be used on vertical mounting surfaces respectively.
